A typical graph of the output I am getting is shown below.
The approx. 1280mV line is the initial output from the magnetometer which should then change dependent on changes to the magnetic field, however what seems to be happening is the output jumping to 1800mV (and superimposed on this level there does seem to be a fluctuating signal) before being pulled down to the initial output voltage, almost as if the device is being periodically reset and held at the reset voltage.
(The change between 13:30 and 14:00 was me checking the wiring again, switching off and on etc.)
There seems to be no logic to the frequency of these changes. I have checked and double checked all wiring, the circuit board etc. but cannot find any cause for this problem.
Not sure where to go now.
